Omnitronic BOB Series User Manual page 26

No. Element
1 Operating mode selector switch
2 LEVEL R control
3 Bluetooth button
4 PHASE reversal switch
5 LEVEL SUB control
6 Status
7 LEVEL L control
8 DSP MODE switch
9 Signal inputs
10 LINK OUT feed-through outputs
11 LINE IN input
12 TO SATELLITE connectors
13 Voltage selector switch
14 Power switch
15 Power input
16 Fuse
Function
• Switch engaged: mono operation
• Switch disengaged: stereo operation
To adjust the level for the right satellite output.
After switching on press and hold the PAIR button for 2
seconds to enter the pairing mode. The LED flashes while
pairing and lights solid when paired. Shortly press the button to
reset the Bluetooth connection.
Allows switching the phase from 0° to 180° when multiple
speakers are operated in parallel.
To adjust the level for the subwoofer.
FAULT: protective circuit is active
LIMIT: the signal level is too high; the limiter will reduce the
signal level to protect the speakers. Reduce the volume with
the master control until the LED does not light anymore, or only
at signal peaks.
SIG: input signal is present
POWER: speaker is powered on
To adjust the level for the left satellite output.
To select various equalizer presets according to your
application: FLAT = frequency response is not affected, LIVE =
high frequency attenuation, DJ = low and high frequency boost,
SPEECH = mid and high frequency boost
Balanced combo inputs (XLR/6.3 mm jack) for connecting
audio units with line level output (e.g. mixer, preamplifier, AV
receiver). When connecting a mono device, only use the left
jack.
Balanced XLR jacks, connected in parallel to the inputs, to
connect another BOB-10A subwoofer or active speaker
system.
Unbalanced RCA jacks for connecting audio units with line
output.
High-pass filtered speaker jacks to connect up to four satellite
speakers each.
Switches between 115 V and 230 V.
Turns power to the subwoofer on and off.
Used to plug in the supplied power cord.
Only replace the fuse when the device is disconnected from
mains. Only use fuses of the same rating and power. The
correct fuse value is specified on the rear panel.
26 • EN