Advertisement
Quick Links
MTH
HOBBY PRODUCTS INDUSTRIAL CO., LTD.
www.mth.com.tw mthhobby@mth.com.tw
MTH HOBBY 2010
EP/GP
No.8706
Warning
An RC aircraft is not a toy! If misused, it can cause serious bodily
harm and damage to property. Fly only in open areas, following all
instructions included with your radio.
Before beginning the assembly, remove each part from its bag for
inspection. Closely inspect the fuselage, wing panels, rudder and
stabilizer for damage. If you find any damaged or missing parts,
contact the place of purchase.
SPECIFICATIONS
WING SPAN: 1600mm
2
WING AREA: 54.5 dm
LENGTH: 1380mm
WEIGHT: 2800g
ENGINE: .60- .70
RADIO: 4 CHANNELS
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Super Flying Model Sbach 342 THUNDERBLOT EP
Summary of Contents for Super Flying Model Sbach 342 THUNDERBLOT EP
- Page 1 EP/GP SPECIFICATIONS WING SPAN: 1600mm WING AREA: 54.5 dm LENGTH: 1380mm No.8706 WEIGHT: 2800g ENGINE: .60- .70 RADIO: 4 CHANNELS Warning An RC aircraft is not a toy! If misused, it can cause serious bodily HOBBY PRODUCTS INDUSTRIAL CO., LTD. harm and damage to property.
-
Page 2: Contents Of Kit/Parts Layout
secure the washer and nut on the stand just like the picture shows. Make sure the rod stand can move freely. Use hobby knife to cut out the covering over the wing joiner slot and the hole for the fiber tube. Connect the servo with 30cm servo extension. - Page 3 Use tape to secure the end of the Secure the control horn with 2mm x Try to locate the vertical and Install the tail wheel onto the tail servo extension on the throttle-out- 15 screws. horizontal in place. Use pencil to gear and secure it with the supplied mark the contacting area.
- Page 4 Place the wing onto the wing saddle Secure the tail gear onto the fuselage Secure the engine on the engine Cut opens the in-take. Use instant of the fuselage, approximately with the supplied screws (2.6x10mm mount with plates, M4x30mm screw glue to secure the top and bottom aligning the wing center with the tapping screws).
- Page 5 Using M4 nut to secure the wheel Place the center of the control horn Install the servos for rudder, elevator Take out the landing gear accessories pant assembly on the aluminum on the elevator at the hold drilled in and throttle. Please note that the (as following) from the hardware bag: landing gear.
- Page 6 Install the wing halves. Use rubber Assemble the power unit as indicated Use hobby knife to cut off the in-take Secure the engine on the engine band (1.5-2.0mm, 40-50mm length) in the picture. and cooling hole on the bottom of mount with 4x30mm screws and to secure the wing halves together.
- Page 7 13mm 19mm 20mm 13mm 19mm 20mm Cut opens the in-take. Use instant Install the spinner set w/propeller. FOR THE GP VERSION glue to secure the top and bottom Secure the spinner with 3 x 10 screw. cowlings together. The recommended Center of Gravity Apply the white decal strap on the location is 133mm back from the conjunction place.
Need help?
Do you have a question about the Sbach 342 THUNDERBLOT EP and is the answer not in the manual?
Questions and answers