Advertisement
Quick Links
NO.8709/8710/8712
Warning
An RC aircraft is not a toy! If misused, it can cause serious bodily
MTH
HOBBY PRODUCTS INDUSTRIAL CO., LTD.
harm and damage to property. Fly only in open areas, following all
www.mth.com.tw mthhobby@mth.com.tw
instructions included with your radio.
Before beginning the assembly, remove each part from its bag for
MTH HOBBY 2013
inspection. Closely inspect the fuselage, wing panels, rudder and
stabilizer for damage. If you find any damaged or missing parts,
contact the place of purchase.
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Super Flying Model 8709
Summary of Contents for Super Flying Model 8709
- Page 1 NO.8709/8710/8712 Warning An RC aircraft is not a toy! If misused, it can cause serious bodily HOBBY PRODUCTS INDUSTRIAL CO., LTD. harm and damage to property. Fly only in open areas, following all www.mth.com.tw mthhobby@mth.com.tw instructions included with your radio.
- Page 2 two diagonals of a square cross in the center of the hole. Use a hobby knife to cut the covering according to the marking lines. Using a sharp hobby knife carefully cut the covering away from each of the holes on the main wing. Use the solder iron to trim the covering around he holes.
- Page 3 and remove the servo tray and drop some CA glue into the screw-holes for reinforcement. (Note: aileron servo must connect with 60cm extension. Flap aileron connects with 30cm extension. It is convenient to use the outer tube included in the hardware bag and a piece of tape to secure the plug on the tube and pull out the plug of the extension.)
- Page 4 Take the main wing strut on the Thread the metal clip onto the rod. When the glue is dried enough, use Take the rubber ring (3x10mm) out of Connect the clip with the control horn. the hardware bag. Insert the rod into hobby knife to remove the extra working table.
- Page 5 Use curved scissors to trim the edge Place the vertical and rudder on the Spread UHU glue on the edge of the plastic rear window and fit it onto the of the sunroof and please reserve working table. Spread superglue on window hole inside the fuselage.
- Page 6 Remove both vertical and horizontal. Use epoxy to glue the vertical and Use hobby knife to remove the covering over the slot for the elevator Use hobby knife to cut off the horizontal in position. and the block on the tail. covering inside the marking area on the horizontal (two sides).
- Page 7 collar into the tail wire. Secure the assembly with 3x4mm hex screw. Fasten the tail wheel assembly on the tail gear w/aluminum blot and nut. Secure the control arm on the bolt with 3mm hex screw. Use 2mm nut and washer to secure Insert the M2x15mm screws and Take the springs out of the hardware bag.
- Page 8 Use plier to open 5mm hook on the Use plier to adjust the hook on the Use UHU glue to secure two pieces Insert the rod of elevator into the end of gear spring. gear spring for hooking on the main of 13.5 x 15 x 41mm blocks on the rod connector.
- Page 9 Try to find the exit for the rudder The linkage assembly after Slide the rubber band through the Use curved scissors to trim the rod on the fuselage. Use hobby assembling. drilled hole on the tank. Connect canopy. Use 2x8mm tapping screws knife to remove the covering.
- Page 10 45mm 45mm Use 3.0mm hex wrench to secure the Try to fit the cowling onto the engine. Cut a small piece of adhesive Velcro main wing inside the fuselage. Use curved scissors to trim the tape and stick on the side window cowling.
Need help?
Do you have a question about the 8709 and is the answer not in the manual?
Questions and answers