Installation Overview; Unpack Your Interwrite Dualboard - Interwrite DualBoard series Getting Started

Interwrite DualBoard
2

Installation Overview

This section describes what you will be doing and the order in which you will
be doing it, to facilitate the installation of your Interwrite DualBoard and its
preparation for use.

1. Unpack Your Interwrite DualBoard

Open the shipping box and remove the Accessory Box. Leave the Interwrite
DualBoard in the box until you are ready to mount it.
In the Accessories section of this guide, you will see that a variety of Inter-
write DualBoard accessories are available to help you create the interactive
environment that best suits your requirements. Following is a basic list of the
Interwrite accessories likely to be included with your Interwrite DualBoard:
Serial Cable
USB Cable
RFCOM and
Workspace RF Hub
Interwrite Pens
• If you are going to connect your Interwrite DualBoard using a cable, only
one cable, either Serial or USB, can be used.
• If you are going wireless, neither cable should be used.
• If your Power Supply shipped with a set of adapters, the instructions for
fitting the correct adapter on the plug are described on page
• If you are connecting your Interwrite DualBoard using a USB cable, the
Power Supply is not needed.
• If you are using a serial connection, attaching the RFCOM module to the
board for wireless communication, or connecting the Interactive Pen
Charging Station to the board's controller, the
TM
Cable Guides
Power Supply
Power Supply Adapters
Wall Mounting Bracket
Mounting Clips
Getting Started
Interwrite Workspace CD
This Interwrite DualBoard
Getting Started Guide
13
Power Supply
is required.
.