Installing The Mounting Clips On The - Interwrite DualBoard series Getting Started

Interwrite DualBoard
30
Installing the Mounting Clips
on the DualBoard and Wall
The two Mounting Clips, found in the Accessory Kit that
shipped with your Interwrite DualBoard, can be used in
conjunction with a wall mount installation of the board. They
fasten the bottom of the Interwrite DualBoard to the wall to
prevent it from being jostled loose from the Wall Mounting
Bracket. Install the Mounting Clips after the Interwrite Dual-
Board is hung from the Wall Mounting Bracket. The hardware for attaching
the Mounting Clips to the wall is not included, as the type of wall on which
they will be mounted varies from installation to installation.
If you are using a ceiling mount projector, be sure the Interwrite
DualBoard is aligned to the projector image before you install the
Mounting Clips to avoid having to reposition the board.
Mounting
Clip
Interwrite
DualBoard Frame
Front of the
Interwrite
DualBoard
Mounting Clip
TM
Back of the
Interwrite DualBoard
1 Hook the Mounting Clip over the lip of
the Interwrite DualBoard frame on the
back of the board. Position a Mounting
Clip in each corner at the bottom of the
board.
2
Mark the location of the holes in each
Mounting Clip on the wall.
3 Install suitable anchors into the wall.
4
Install screws to secure the Mounting
Clips to the wall. Use two screws per
Clip. The recommended screw size is
number 8 or M4.
Getting Started