Nilfisk-Advance SR 1000S B Instructions For Use Manual
  1. Manuals
  2. Brands
  3. Nilfisk-Advance Manuals
  4. Blower
  5. SR 1000S B
  6. Instructions for use manual

Nilfisk-Advance SR 1000S B Instructions For Use Manual

Hide thumbs Also See for SR 1000S B:
Table of Contents

Advertisement

Quick Links

See also: Instructions for Use Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SR 1000S B and is the answer not in the manual?

Questions and answers

Related Manuals for Nilfisk-Advance SR 1000S B

Summary of Contents for Nilfisk-Advance SR 1000S B

  • Page 3 S311282 S311283...
  • Page 4 S310027 S310028 S310029 S310030 S310198 S310032 S310199 S310034...
  • Page 5 S310200 S310036 S310037 S310083 S310084 S310085 S310040 S310041 S310201...
  • Page 6 S311284...
  • Page 7 S3111285...

  • Page 8: Table Of Contents

    USER MANUAL INTRODUCTION ........................... 2 MANUAL PURPOSE AND CONTENTS ......................2 TARGET ................................2 HOW TO KEEP THIS MANUAL ........................2 CONFORMITY CERTIFICATE ......................... 2 IDENTIFICATION DATA ........................... 2 OTHER REFERENCE MANUALS ........................2 SPARE PARTS AND MAINTENANCE ......................2 CHANGES AND IMPROVEMENTS .........................

  • Page 9: Introduction

    Contact Nilfisk-Advance in case of doubts regarding must be carried out by qualified personnel or by the interpretation of the instructions and for any further Nilfisk-Advance Service Centers listed at the end of this information. Manual. Only original spare parts and accessories must be used.

  • Page 10: Safety

    Do not allow to be used as a toy. Close attention is DANGER! necessary when used near children. – Use only as described in this Manual. Use only Nilfisk-Advance recommended accessories. – Remove the key from the ignition switch and disconnect – Do not leave the machine unattended with the key...

  • Page 11: Unpacking/Delivery

    USER MANUAL UNPACKING/DELIVERY – Do not wash the machine with direct or pressurised water jets, or with corrosive substances. Do not use Upon delivery carefully check that the machine and its compressed air to clean this type of machine. packing have not been damaged during transportation. In –...

  • Page 12: Machine Description

    USER MANUAL MACHINE DESCRIPTION Outside view (See Fig. C) OPERATION CAPABILITIES Steering wheel Control panel This sweeper has been designed and built to clean (by Vacuum activation/deactivation lever sweeping and vacuuming) smooth and solid floors, in civil and Side broom lifting/lowering lever industrial environments and to collect dust and light debris Forward/reverse gear pedal under safe operation conditions by a qualified operator.

  • Page 13: Technical Data

    USER MANUAL TECHNICAL DATA Under-hood compartment (See Fig. U) Serial number plate/technical data/EC certification General Values Hood (open) Machine length 1,255 mm Hood support rod Machine width (without side brooms) 795 mm Batteries Machine height 1,155 mm Battery caps (for WET batteries) Battery connector Working width (with/without side 1,000/600 mm...

  • Page 14: Accessories/Options

    USER MANUAL Wiring diagram Colour code (See Fig. V) Black Blue BAT: Batteries Brown BE1: Pivoting light Green BZ1: Reverse gear buzzer Grey Battery connector Orange CH1: Battery charger Pink EB1: Hour counter and battery voltage display EB2: Drive system electronic board Violet ES0: Starting relay...

  • Page 15: Use

    USER MANUAL WET batteries installed on the machine but without electrolyte WARNING! 1. Open the machine hood (10, Fig. C) and engage the On some points of the machine there are some hood support rod (3, Fig. U). adhesive plates indicating: 2.

  • Page 16: Wet Or Gel Battery Setting

    USER MANUAL WET OR GEL BATTERY SETTING MACHINE START AND STOP According to the type of batteries (WET or GEL), set the Starting the machine electronic board of the machine and of the battery charger (if Sit on the driver's seat (29, Fig. C) and, if it is necessary equipped), according to the following procedure: for an easier access to the machine, push the lever (15, Turn the ignition switch (2, Fig.

  • Page 17: Machine Operation

    USER MANUAL Stopping the machine HOPPER DUMPING To stop the machine, release the pedal (5, Fig. C). To Stop the machine by releasing the drive pedal. stop the machine more quickly, also press the service Turn the ignition switch (2, Fig. B) to “0” position. brake pedal (6, Fig.

  • Page 18: Maintenance

    USER MANUAL MAINTENANCE The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance. The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions, which are to be defined by the person in charge of the maintenance. WARNING! To carry out maintenance procedures, switch off the machine (remove the key from the ignition switch) and, if necessary, disconnect the batteries.

  • Page 19: Main Broom Height Check And Adjustment

    USER MANUAL MAIN BROOM HEIGHT CHECK AND MAIN BROOM REPLACEMENT ADJUSTMENT NOTE Brooms of various hardness are available. This NOTE procedure is applicable to all types of brooms. Brooms of various hardness are available. This procedure is applicable to all types of brooms. CAUTION! Check that the main broom is at the correct height from It is advisable to use protective gloves when...

  • Page 20: Side Broom Height Check And Adjustment

    USER MANUAL SIDE BROOM HEIGHT CHECK AND CLOSED POCKET FILTER CLEANING AND ADJUSTMENT INTEGRITY CHECK NOTE NOTE Brooms of various hardness are available. This Besides the standard paper filter, polyester procedure is applicable to all types of brooms. filters are also available. The following procedure is applicable to each type of filter.

  • Page 21: Skirt Height And Operation Check

    USER MANUAL SKIRT HEIGHT AND OPERATION CHECK Front and rear skirt check Remove the main broom, as shown in the relevant Drive the machine on a level ground that is suitable for paragraph. checking the skirt height. Engage the parking brake (6 Check the front (1, Fig.
  • Page 22 USER MANUAL Drive the machine on a level ground and engage the Charging the batteries with the battery charger parking brake (6 and 7, Fig. C). (optional) Turn the ignition switch (2, Fig. B) to “0” position. Open the hood (10, Fig. C) and engage the hood support (For WET batteries only) check the level of electrolyte rod (3, Fig.

  • Page 23: Safety Functions

    – Batteries – Polyester dust filter – Main and side brooms – Electrical and electronic components (*) – Plastic components and hoses Refer to the nearest Nilfisk-Advance Center especially when scrapping electrical and electronic components. 146 1957 000...

Table of Contents