Important Safety Instructions - Compress IUV600S SERIES User Manual

Compress iUV600s Series User Guide

1.2 Important Safety Instructions

General safety instructions that must be observed to use the equipment safely are explained below.
ALWAYS CONSULT YOUR PRODUCT REPRESENTATIVE PRIOR TO SWITCHING ON YOUR MACHINE
WARNING
Do not place the printer in the following areas. Doing so may result in the printer tipping or falling
over and causing serious injury.
Unstable or loose surfaces
Angled surfaces
Areas subject to vibration by other equipment
Do not stand on or place heavy objects on your printer. Doing so may result in the printer tipping or
falling over and causing injury.
Do not look directly at the LED UV lamp whilst the machine is in operation, this can be damaging to
human eyes. The use of UV proof sunglasses is strongly recommended
Do not cover the ventilation hole of your printer with cloth, such as a blanket or table cloth. Doing so
could obstruct ventilation and cause fire.
Do not place the printer in humid and dusty areas. Doing so may result in electrical shock or fire.
Make sure to use the power cable packed with the printer you purchased. Not doing so may result in
electrical shock or fire.
Do not use the power cable if it is damaged in any way. Doing so may result in electrical shock or fire.
Do not insert or drop metal or objects which are easily combustible through the openings such as the
ventilation hole of your printer. Doing so may result in electrical shock or fire.
Do not operate the printer if it has been contaminated by foreign substances or liquid spills as doing
so may result in electrical shock or fire. Immediately turn off the power switch, disconnect the power
plug from the electric socket, and contact your authorized DTG Dealer.
Make sure to use only the specified power supply (AC 100 V - 120 V or AC 220 V - 240 V). If the power
supply other than the specified voltage is used, it could cause an electric shock and fire.
Make sure to double check LED curing lamp voltages are set for your specific countries voltage rating.
Take power for the printer directly from the power socket (AC 100 V - 120 V or AC 220 V - 240 V). Do
not use complex multiple plugs on the same socket. This could generate heat and might cause fire.
Make sure that the following is performed before parts replacement.
Turn off the power to the printer.
Remove the power cable from the power outlet. Not doing so may cause electric shock or
damage to the electric circuit.
Unplug the cables connected to the printer. Failure to do so could result in damage to the
printer.
8
Safety Instructions