Re-Installing The Upright - GE Giraffe Service Manual

6. Using a 3mm hex key, remove the 2 screws that secure the display module to the nut bar and pull the nut
bar up and out of the upright. Using a 3mm hex key, remove the screw that attaches the ground wire. Be
careful not to drop the star washers down into the upright.
7. Hold on to the upright, and using a 4mm hex key, remove the 2 screws in the holes in the lower side of the
upright . Remove the entire upright.

5.3.1 Re-installing the Upright

1. To assist in reattaching the upright to the unit, there are four mounting studs on the bracket casting
that mate with four holes in the upright. Place the upright on the studs. Be careful not to pinch any wires
between the unit and the upright.
2. Secure the upright to the unit by reinstalling the 2 screws in the holes inside the upright. Apply Loctite
to the screws. Be careful not to drop the screws into the upright.
3. Attach ground wire to rail. Fasten the display module to the upright with the two screws and nut bar
removed earlier.
4. Reinstall the wire cover. Take care to route the wires in the upright channels and not to pinch them with the
cover when securing with the screw.
5. Reinstall the hood latch receptacle with the two screws removed earlier.
6. Attach ground wire to rail. Fasten the display module to the upright with the two screws and nut bar
removed earlier.
7. Fasten the back panel to the display module with its 4 mounting screws.
8. Slide the decorative strip up and install the end caps.
© 2001 by Datex-Ohmeda, Inc.. All rights reserved.
Chapter 5: Repair Procedures
6600-0356-000 103
242
TM
69