Controller And Display Module Procedures; Display Module; Figure 5-12 Display Module - GE Giraffe Service Manual

5.8 Controller and Display Module Procedures

5.8.1 Display Module

Refer to "Figure 5-12 Display Module".
Module housing
NOTE: Illustration expanded for
clarity.
1. Using a 2mm hex key, remove the 4 button head socket screws and lock washers that secure the back
cover to the display module and remove the panel.
2. To remove the display driver board, first remove the 4 screws the hold the board to the standoffs, then
disconnect the electrical connectors.
3. To replace the rotary encoder for the EL display, pull the control knob off the shaft, disconnect the electrical
connector, remove the nut that secures the encoder, and remove the encoder.
4. To remove the LED board, disconnect the electrical connectors, then remove the 2 standoffs (6mm wrench)
that hold the board in place, and then the 2 nuts with hardware.
© 2001 by Datex-Ohmeda, Inc.. All rights reserved.
Back cover
Display driver board
LED board
EL display
Rotary encoder
Display bezel

Figure 5-12 Display Module

6600-0356-000 103
Chapter 5: Repair Procedures
Membrane switch panel
Control knob
87