Installation; Configure Sub Module Address - HIKVISION DS-KD8003-IME1 User Manual

4 Installation

Before you start:
 Make sure the device in the package is in good condition and all the assembly parts
are included.
 Set the sub module address before start the installation steps.
 Make sure the place for surface mounting is flat.
 Make sure all the related equipment is power-off during the installation.
 Tools that you need to prepare for installation:
Drill (ø6), cross screwdriver (PH1*150 mm), and gradienter.
 Buy corresponding accessory package for installation. The accessory package model
and its suitable installation method as below:
Package
Model
DS-KD-ACW1
DS-KD-ACW2
DS-KD-ACW3
DS-KD-ACF1
DS-KD-ACF2
DS-KD-ACF3

4.1 Configure Sub Module Address

You need to set the sub module address via DIP before installation.
Steps:
1. Remove the rubber cover on the sub module rear panel to expose the DIP switch.
Video Intercom Module Door Station·User Manual
Mounting Method
One-Module Surface Mounting
Two-Module Surface Mounting
Three-Module Surface Mounting
One-Module Flush Mounting
Two-Module Flush Mounting
Three-Module Flush Mounting
Figure 4-1 DIP Switch
Note
Install the device according
to the instructions.
Not all the lines in the
accessory package will be
used.