Chapter 6: Changing Sleeves Between Patients; Replacing Disposable Sleeves - iTero Element 5D Configuration Operation Manual

Laptop
Hide thumbs Also See for Element 5D:
Table of Contents

Advertisement

iTero Element 5D laptop configuration operation manual
Chapter 6:
Changing sleeves
between patients
iTero Element 5D laptop configuration sleeve is intended for single
patient use and shall be replaced after each patient with the purpose
to avoid cross contamination.
For sleeve replacement proceed with the steps below.
CAUTION: Dispose of scanner sleeves according to standard
operating procedures or local regulations for the disposal of
contaminated medical waste.

Replacing disposable sleeves

Step 1
When pulling a sleeve OFF or ON, hold the center of the sleeve.
Step 3
Gently slide on new sleeve onto scanning unit until it clicks into
place.
English
Step 2
Press slightly on both sides of the disposable sleeve, pull the sleeve
slowly off the scanning unit and discard.
WARNING: Optical surface!
DO NOT touch the optical surface. Contact may cause damage.
If cleaning is necessary, use the wipes and anti-static cloth found
inside the sleeves box. For proper use, refer to the directions found
in the scanner sleeves box.
12

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Element 5D and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents