Setting The Operating Force; Photo-Beam Setting - GarageAce S6 User Manual

The opener will operate a cycle
automatically to remember the limit
positions and the original opening and
closing force, then return to standby mode.
During learning, if the door stops unusually,
and flashes either "H", "C", "O" or "L" for
5 seconds, this indicates a problem. If this
happens, see the Troubleshooting Guide on
page 16.

Setting the Operating Force

This operation will set the operating force
of the door when opening or closing. The
default force is 5. This will not normally
need adjusting and will only be required if
the door is struggling to open or close or is
not reacting appropriately to obstructions.
Press and hold the "SET" button for 3
seconds until the LED flashes "1". Press
the "UP" or "DOWN" button until the LED
flashes "2", then press the "SET" button.
The unit is now in force adjustment mode.
The LED displays the current set force.
Press "UP" button to increase the force and
"DOWN" button to decrease the force.
The maximum force is 9 and the minimum
is 1. Press the "SET" button to confirm
the setting and the opener will return to
standby mode.

Photo-Beam Setting

This operation is only required if you are
setting up a photo-beam sensor which is an
accessory available separately. The default
setting of photo-beam is "0".
Press and hold the SET" button for 3
seconds until the LED flashes "1". Press
"UP" or "DOWN" button until the LED
flashes "3", then press the "SET" button.
The unit is now in Photo-Beam setting
mode. The LED displays the current setting.
Press the "UP" button until the LED displays
"1". The photo-beam function is now
active. Press the "DOWN" button until the
LED displays "0". The photo-beam function
SET UP
M
CODE DOWN
SET UP
M
CODE DOWN
S6 Instruction Manual
TM
13