Page 1
S6 Sectional/Tilt Garage Door Opener User Manual...
Page 2
It is vital for your safety to follow all the instructions and safety warnings in this booklet. Failure to do so could result in serious personal injury, damage to your property or damage to your new garage door opener. Please save these instructions for future reference. S6 Instruction Manual...
1 to 9 minutes. This function is optional. Fault Checking: The opener will check for faults and show the code on its LED display. This makes adjustment and maintenance easy. Easy Operation: Settings are shown on the LED display, making operation easy. S6 Instruction Manual...
The Entrapment Warning Label should be attached in a prominent location. 10. Check the function of the opener on a monthly basis! 11. Please take good care of this manual after installation so you can refer to it for regular safety inspections and maintenance. S6 Instruction Manual...
17. The installation and wiring must comply with local regulations. Work safely! Always wear appropriate safety protection when using any tools. For garages without a second access, an additional emergency release is necessary, which prevents a possible lock out. S6 Instruction Manual...
WARNING: Make sure the opener is attached to a solid ceiling and not to plasterboard. Failure to have a safe and secure fixing will lead to opener falling, and cause serious personsal and/or property damage. Fig 4 S6 Instruction Manual...
Fig 6 Step 2 - Attach the Motor Door bracket Wall bracket Axis pin ø8x90 and split pin Shuttle U-brackets Hanging bracket Bent arm Straight arm Fig 7 S6 Instruction Manual...
NOTE: Make sure the track is at right angles to the door and about level. Make Fig 10 sure the ceiling is sturdy enough where the hanging bracket connects. S6 Instruction Manual...
The remotes normally come pre- programmed. You can, however, program the buttons manually. CODE DOWN Press and hold the “Code” button for 1 second until the LED dot comes on. Press the desired remote or wall switch button S6 Instruction Manual...
You can fine-tune the position using the “UP” or “DOWN” buttons. (The LED flashes “n” or “u” during opening or closing.) Then press “SET” button to save the position. S6 Instruction Manual...
The unit is now in Photo-Beam setting mode. The LED displays the current setting. Press the “UP” button until the LED displays “1”. The photo-beam function is now active. Press the “DOWN” button until the LED displays “0”. The photo-beam function S6 Instruction Manual...
(fig 12) and move door by hand. To re-engage the door, simply run opener in automatic mode or move the door by hand until the belt catch engages with the Fig 12 shuttle. S6 Instruction Manual...
Make sure that the safety devices are working effectively (photo beams, etc.) Check belt drive remains tight at least twice a year. Note: A badly operating door can affect the life of the automatic opener due to incorrect loads, and will void the warranty. S6 Instruction Manual...
1. Check that the memory is full and 2. New remote is from another clear if required (see page 11) brand 2. Use GarageAce™ remotes only LED displays “C” – opener doesn’t 1. Motor cord is loose 1. Reinsert motor cord work 2.
Newfield Group warrants to the original purchaser (“the buyer”) that the GarageAce™ door opener (“the unit”) sold under this warranty will be free from defects of materials and workmanship for a period of 12 months from date of purchase.
Page 20
Distributed in New Zealand by Newfield Group PO Box 11303, Christchurch, New Zealand 0800-600-789 www.garageace.co.nz...