Step 5 - Install The Drawbar; Step 6 - Final Adjustments Using The Remote; Coding Remotes & Wall Switch - GarageAce S6 User Manual

Step 5 - Install the Drawbar

Close the door, pull down the clutch handle
(part 1), and move the shuttle close to
the door (Fig 11). The horizontal distance
between the shuttle and the door should be
300-400mm.
Use one of the ø8x25 pins to attach the
straight drawbar (part 2) to the connection
hole in the clutch (part 1) and secure using
the split pin (part 6). Use the remaining
ø8x25 pin to attach the bent drawbar
(part 5) to the connection hole of the door
bracket (part 7) and secure using the split
pin (part 6).
Connect the straight drawbar to the bent
drawbar using the two M8x20 bolts (part
3) and lock tightly using the two flange
hexagon header nuts M8 (part 4).
Adjust the length of the rope attached
to the clutch so the height from the rope
handle (part 8) to the ground is not less
than 1.8 meters.

Step 6 - Final Adjustments Using the Remote

Plug the motor unit into a power outlet and
turn on. The LED panel will count down
from 9 to 0 and then display 11.
Coding Remotes & Wall
Switch
The remotes normally come pre-
programmed. You can, however, program
the buttons manually.
Press and hold the "Code" button for 1
second until the LED dot comes on. Press
the desired remote or wall switch button
300-400mm
2
5
Door
6
7
Fig 11
SET UP
M
CODE DOWN
SET UP
M
CODE DOWN
S6 Instruction Manual
1
3 4
8
TM
11