Continuous Output Mode - M-system R3-PD16B Instruction Manual

• Data Length: 8 bits
Example that ON/OFF control outputs sequentially Ch2 to Ch1 is shown below.
Example of when I/O Mode is in Output Operation (SW2-7: OFF) and ON/OFF Control channel is Not Swapped (SW2-8: OFF).
(1) Output data Do 1 changes from 0 to 1.
(2) After Do 1's rising edge, Ch2's one-shot output turns ON for a fixed period of time (SW1's time set).
(3) After one-shot output completion, Di 2 (Ch2 output completed status) changes from 0 to 1.
(4) When Do 1 changes from 1 to 0, Di 2 changes from 1 to 0.
(5) After Do 1's sinking edge, Ch1's one-shot output turns ON for a fixed period of time (SW1's time set).
(6) After one-shot output completion, Di 1 (Ch1 output completed status) changes from 0 to 1.
Do 1
Ch1
Ch2
Di 1
(Ch1 Output Completion Status)
Di 2
(Ch2 Output Completion Status)
Note: During one shot output is on, rising edge and sinking edge are not detected.

■ CONTINUOUS OUTPUT MODE

Example of Ch1 is shown below.
Example of I/O Mode is in Output Operation. (SW2-7: OFF)
Do 1
Ch1
Di 1
(Ch1 Output Completion Status)
(1) (4)
(5) One Shot Output
(2) One Shot Output
(3) Ch2 One Shot Output Completion
5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp
(6) Ch1 One Shot Output Completion
R3-PD16B
EM-8390 Rev.2 P. 5 / 10