Other Possible Problems - V-ZUG SUPREMO XSL Operating Instructions Manual

Problem
The milk contains large
bubbles and squirts out of
the milk spout or there is
little froth.
The milk does not come
out of the milk spout.
9.3

Other possible problems

Problem
The appliance does not
come on.
The infuser cannot be ex-
tracted.
The appliance requests a
third rinse cycle at the
end of descaling.
Possible cause
▪ The milk is not cold
enough.
▪ The milk used was
not skimmed or semi-
skimmed.
▪ The adjusting knob
was not turned cor-
rectly to one of the
three milk positions.
▪ The lid of the milk
frother is dirty.
▪ The adjusting knob of
the milk frother is
dirty.
▪ The connection
nozzle is dirty.
▪ The lid of the milk
frother is dirty.
▪ The milk tube has not
or not correctly been
inserted.
Possible cause
▪ The plug (of the
mains cable) is not
plugged into the
mains socket.
▪ The appliance is dis-
connected.
▪ The main switch is
not turned on.
▪ The appliance has
not been switched off
correctly.
▪ The water tank was
not filled to the MAX
level.
9 Trouble-shooting
Solution
▸ Use skimmed or semi-
skimmed milk at a temperat-
ure of 5 °C.
▸ Turn the adjusting knob to the
left or right until set to the re-
commended position (see
page 23).
▸ Clean the lid and adjusting
knob of the milk frother (see
page 36).
▸ Clean the connection nozzle
(see page 38).
▸ Clean the lid of the milk
frother (see page 36).
▸ Insert the milk tube in the
milk frother lid (see page 13).
Solution
▸ Plug into the mains socket.
▸ Press the main switch (see
page 14).
▸ Press the ON/OFF
(see page 19).
▸ Empty the drip tray.
▸ Follow the instructions dis-
played by the appliance and
perform a third rinse cycle.
button
47