Assembling The Bed Ends - Invacare G5510 User Manual

6.4

Assembling the Bed Ends

Installing the Casters
WARNING!
Risk of Injury or Damage
Ensure that all four casters are locked and that the
bed does not move before transferring.
- DO NOT transfer occupant to the bed if bed is
not stable.

For this procedure, refer to FIGURE 6 on page 49.
1. Lay the bed end flat on the floor.
Installing/Removing the Bed Ends
Installing

For this procedure, refer to FIGURE 7 on page 50.
1. Stand one bed end as close to the head section as possible (Detail "A").
2. Grasp the head section, by the side, and raise it until the rivets on the corner plates of the section are high enough to place into the corner locks
on the bed end (Detail "A").
Part No 1180159
6 DEALER SECTION - PACKAGING, HANDLING, AND SET-UP
2. Insert the shaft of a locking caster assembly into the caster socket
in the leg of one of the bed ends.
3. To prevent excess movement of the bed during assembly, lock the
caster. Refer to Operating the Locking Function on the Locking
Caster on page 38.
4. Repeat STEPS 1-3 for the remaining casters.
Bed End
49
Shaft
FIGURE 6 Assembling the Bed Ends
Locking Caster
Floor
Caster Socket
®
Invacare G5510 Bed