Siemens SIMATIC ET 200S Hardware Installation And Operating Manual page 207

Table 2-3
Terminal
3
4
A4
A3
7
8
A8
A7
9
10
11
12
A12
A11
13
14
15
16
A16
A15
Caution
Parallel wiring must be carried out if high current is likely to occur on OUT 1 or OUT 2.
• for OUT 1: the terminals 9/10 and 13/14
• for OUT 2: the terminals 11/12 and 15/16
Otherwise, an overheating of the terminal caused by the current load cannot be ruled out.
Product Information for the Distributed I/O System ET 200S, Fail-Safe Systems Manual
Product information, 07/2006, A5E00825271-01
2.3 Terminal Assignment for EM 1F-RO DC24V/5A AC24..230V/5A
Terminal assignment of TM-P30S44-A0 and TM-P30C44-A0
Designation
IN P Terminal for control voltage DC 24V
IN M Terminal for control voltage ground
AUX 1 at TM-E...46-A1: AUX 1 bus implemented. Connection with the
terminals A3 to A16 for any PE contact.
Individual grouping of load current supply is possible.
AUX 1 at TM-E...46-A1: AUX 1 bus implemented. Connection with the
terminals A3 to A16 for any PE contact.
Individual grouping of load current supply is possible.
IN P Terminal for control voltage DC 24V
IN M Terminal for control voltage ground
AUX 1 at TM-E...46-A1: AUX 1 bus implemented. Connection with the
terminals A3 to A16 for any PE contact.
Individual grouping of load current supply is possible.
AUX 1 at TM-E...46-A1: AUX 1 bus implemented. Connection with the
terminals A3 to A16 for any PE contact.
Individual grouping of load current supply is possible.
OUT 1 (13) 13, 14: Contacting element, channel 0 for fail-safe switching load 1
OUT 1 (14)
OUT 2 (23) 23, 24: Contacting element, channel 1 for fail-safe switching load 2
OUT 2 (24)
AUX 1 at TM-E...46-A1: AUX 1 bus implemented. Connection with the
terminals A3 to A16 for any PE contact.
Individual grouping of load current supply is possible.
AUX 1 at TM-E...46-A1: AUX 1 bus implemented. Connection with the
terminals A3 to A16 for any PE contact.
Individual grouping of load current supply is possible.
OUT 1 (13) 13, 14: Contacting element, channel 0 for fail-safe switching load 1
OUT 1 (14)
OUT 2 (23) 23, 24: Contacting element, channel 1 for fail-safe switching load 2
OUT 2 (24)
AUX 1 at TM-E...46-A1: AUX 1 bus implemented. Connection with the
terminals A3 to A16 for any PE contact.
Individual grouping of load current supply is possible.
AUX 1 at TM-E...46-A1: AUX 1 bus implemented. Connection with the
terminals A3 to A16 for any PE contact.
Individual grouping of load current supply is possible.
Digital Electronics Module 1 F-RO DC24V/5A AC24..230V/5A
2-5