Assemble The Packed Stuffing Box (E-1531/E-1532-Pf); Reinstall The Rotating Assembly And Motor - Xylem e-1532 Series Instruction Manual

6 Maintenance
1. O-rings
2. Motor end
Figure 6: Double mechanical seal (e-1531/e-1532–D)
3. Insert another stationary seal and O-ring into the coverplate.
4. Slide the seal cap onto the shaft.
5. Replace the seal cap gasket.
6. Slide the rotating portion of the seal assembly onto the shaft sleeve.
7. Assemble the coverplate onto the bracket.
8. Tighten the capscrews according to the Capscrew torque values table.
9. Attach the seal cap to the coverplate.
10.Tighten the hex nuts on the seal cap bolts according to the Capscrew torque values
table.

6.4.2 Assemble the packed stuffing box (e-1531/e-1532-PF)

1. Insert two packing rings into the stuffing box.
2. Insert the lantern ring and the last two pieces of packing.
Make sure that the joints on the packing rings are staggered 90º.
3. Install, but do not tighten, the packing gland.
4. Install the coverplate over the pump shaft.
5. Tighten the capscrews according to the Capscrew torque table in the Maintenance
chapter.
6. Tighten the packing gland to compress the packing.
See the note on the packed pump operation in the Operations chapter for more
information.

6.4.3 Reinstall the rotating assembly and motor

1. Install the impeller, impeller washer, lock washer, and capscrew, and then tighten per
the Capscrew torque values table.
2. Install a new volute gasket.
3. Install the rotating assembly and motor into the volute.
4. Tighten the volute capscrews according to the Capscrew torque values table.
26
1. Flushing tube
2. Coverplate capscrew
3. Packing gland
4. Bracket
5. Coverplate
1
2
3
4
5
Series e-1531 and e-1532 INSTRUCTION MANUAL