Reasons why the Protocol Software is displaying
- Not enough measurements have been saved in memory. For the Protocol Software to work there needs to be
28 measurements saved in memory, 4 measurements taken for 7 days.
If you are sure that you want to permanently remove all stored memories, first choose the mode you want to delete
the memory from, then press the SET button 9 times until "
button until "
CL
symbols "
" and "
no
The bars on the left hand side of the display show you the range within which the indicated blood pressure
values lies. Depending on the height of the bar, the readout value is either within the normal (green), borderline
(yellow) or danger (red) range.
The classification is based on standards adopted by Hypertension
Canada.
The indicator bar rises according to your measurement.
measurement is in the green zone, or "Normal".
"High Normal".
Blood Pressure with Self / Home Monitoring".
"Moderate to Severe Hypertension".
This blood pressure monitor allows you to set two alarm times at which an alarm signal will then be triggered.
This can be a useful aid, for instance as a reminder to take your measurements for the Protocol Software (7D
Mode) or to remind you to take medication.
1. To set the alarm, while the monitor is OFF, press the SET button 8 times, "
or "-" buttons to switch between the alarm being OFF or ON. Select "
3. Once Alarm 1 is set, you can follow the same steps above to set Alarm 2.
7D mode General mode
" flashes 3 times to clear the memory. After this, press either the "+" or "-" button, the
" will appear on the screen. This means that the memory has successfully cleared.
"+" or "-" buttons to change the HOUR digits, press SET button to confirm.
7D mode General mode
7D mode General mode
" appears when the power is off. Press the
CL
Yellow
Green
Green
"+" or "-" buttons to change the digits, press SET to confirm.
7D mode General mode
SYS
14 5
Red
135-14 5
Red
121-134
110-120
110
" and press the SET button. The
7D mode General mode
DIA
(mmHg)
95
85-95
80-84
71-80
70
"+"
Need help?
Do you have a question about the PROTOCOL 7D MII and is the answer not in the manual?
Questions and answers