Inserting The Batteries; Using The Device; Select The User - BIOS PROTOCOL 7D MII Instruction Manual

2.3 Inserting the Batteries

Follow these steps to insert four "AA" batteries in to the device.
1. Open the battery compartment cover in the direction shown.
2. Insert four "AA" batteries with the correct polarity as
indicated.
3. Replace the battery compartment cover.
You may also operate this monitor using the included AC/DC
adapter. Use only the included adapter to avoid damaging
the unit.
1. Ensure that the AC/DC adapter and cable are not damaged.
2. Plug the adapter cable into the AC/DC adapter port on the
top of the blood pressure monitor.
3. Plug the adapter into your electrical outlet. When the
adapter is connected, no battery current is consumed.

3. Using the Device

This section describes how to get the maximum benefit from your blood pressure monitor. Follow the
instructions carefully to get an accurate measurement of your blood pressure and pulse rate.

3.1 Select the User

1. Start with the monitor OFF, but with batteries or adapter inserted.
2. Press the / button to switch between User 1 and User 2.
3. Press
been replaced.
batteries from the device.
rechargeable batteries.
button to confirm. The monitor will power off.
LR6(AA)
1.5Vx4