BIOS PROTOCOL 7D MII Instruction Manual page 14

- Rest for 5 minutes before taking a measurement
- Sit at a table with your arm supported and legs uncrossed
- Avoid all movement and muscle tension
- Breathe normally and do not speak
- Wait at least 1 minute between consecutive measurements
- AM & PM measurements should be taken 10-12 hours apart
To start your measurement, see section 3.6 Measuring Your Blood Pressure.
Once the Protocol is complete, after the 7 days, you can view your average. See section 3.9B Recalling Memory
in 7D Mode.
diagnosis.
1. Take 2 measurements in the morning (ideally after going to the bathroom and before eating
or drinking).
and ideally not immediately after the evening meal.
3.5 General Mode
In General Mode, a user can take blood pressure measurements outside of the Protocol
Software (7D Mode).
1. When the monitor is OFF, press the SET button, a small triangle will appear above 7D
Mode on the monitor. Press the "+" or "-" buttons to switch between 7D Mode and
General Mode. Press SET to confirm.
2. Next, select the user. Press SET to confirm, then press
off the monitor.
3. To start your measurement, see section 3.6 Measuring Your Blood Pressure.
1. Press the
button again to continue with the measurement. You will hear 2 short beeps and after "
the cuff is shown on the display.
button until all the symbols appear on the screen. Right after "
7D mode General mode
button to power