Ramp; Ac-Side Components (1×D8T, Rittal Ts 8 Enclosure); Common Ac Flat-Pls Assembly - ABB ACS880-04 Hardware Manual

Ramp

The ramp is used for installing and replacing the D8T module in the Rittal TS 8 enclosure.
Note: Do not use the ramp with plinth heights over 100 mm. The ramp is designed for a
plinth height of 100 mm (the standard plinth height of Rittal TS 8 cabinets).
See the dimension drawing, see section
Frame Enclosure
size
R8i All
AC-side components (1×D8T, Rittal TS 8 enclosure)


Common AC Flat-PLS assembly

When using the Rittal Flat-PLS system, this kit is used for correct positioning of the
common AC bus in the Rittal TS 8 enclosure.
Note: The designs presented in this manual for Rittal TS 8 enclosures employ the Rittal
Flat-PLS busbar system. Make sure that the current carrying capability of the busbars is
not exceeded at any point of the drive system.
Frame Enclosure
size
All 400 mm
Qty Ordering code
1 3AUA0000120467
Qty Ordering code
1 3AUA0000115905
Ramp on page 390.
Kit code
A-468-8-304
Kit code
A-468-X-011
Ordering information 189
Illustration
Illustration
Instruction code: 3AUA0000115893