Buffalo WCR-HP-GN User Manual page 20

Chapter 3 Installation
5
Open the web configuration interface (page 21).
6
In the [Mode information] menu, select [Bridge Mode], then click [Apply].
7
8
The web configuration interface will open. Click [Wireless Config] , then [WDS].
9
Check [Use].
10
Follow the directions below.
AOSS Settings
Select [AOSS] from [Connection type] and click the AOSS button. Also push the AOSS button
on the unit intended to connect. Automatic configuration will take about a minute. To return
the unit to its original IP address settings, refer to Appendix C.
WCR-HP-GN User Manual
When this below screen appears, re-enter
the web configuration interface username
"root" and password. Click [OK].
19