Advertisement
11 PROBLEMS AND ANOMALIES (USER)
PROBLEM
THE L1 LED INDICATOR DOES
NOT TURN ON
THE WASH PROGRAM DOES
NOT START
POOR WASHING RESULTS
RINSE INSUFFICIENT
GLASSES AND SILVERWARE
ARE STAINED
WATER IS PRESENT IN THE
TANK AFTER DRAINING
19
POSSIBLE CAUSE
There is no electrical current
The dishwasher has not finished
loading
Sprinkler wash holes are clogged
or encrusted
Detergent or rinse-aid insufficient
or not adequate
Plates / glasses poorly positioned
Low wash temperature
Inadequate cycle setting
Sprinkler nozzles clogged
Calcium
encrustations
boiler
Rinse-aid
inadequate
dispensed correctly.
Water is of a hardness level
above 12°dF or contains many
dissolved salts
Drainage tube is positioned poorly
or is partially blocked
POSSIBLE REMEDY
Verify the electrical current connection.
Wait for the
red.
Disassemble and clean the sprinklers
(10.2 Periodic checks)
Verify detergent type and quantity.
Arrange plates / glasses accordingly.
Verify the temperature shown on the
display, if below 50°C call Assistance.
Increase the duration of the wash
cycle, particularly if dishes are very
dirty or contain partially dried residues.
Verify the cleanliness of the nozzles
and the correct function of any
in
the
installed water softeners.
or
not
Verify the rinse-aid container and
ensure its adequacy for use with the
water supply. If the problem persists
contact assistance.
Verify that the dishwasher's tube and
drain are not blocked and that the
drain is not in too high of a position;
see the connection diagram.
led indicator to turn
Advertisement
