Permobil M1 User Manual page 288

M1
1. Switch off the wheelchair.
2. Check that all visible cables and the cable to the control panel are
connected correctly.
3. Switch the wheelchair on again. If the fault persists, count the
number of flashing LEDs and check for a possible cause and
remedy in the following table.
4. Do not use the wheelchair until the problem has been remedied
or you have received other information from your service
provider.
WARNING!
Performing diagnostics
Diagnostics may only be performed by personnel with knowledge of the
wheelchair's electronic control system. Incorrect or poorly performed
repair works may make the wheelchair dangerous. Permobil accepts no
liability for any personal injury or damage to the wheelchair and its
surroundings that occur due to incorrect or poorly performed repairs.
288
Troubleshooting