EN
CONNECTION
- Connect the AIP-4010 transmitter to the local area network using the Ethernet port, RJ-45.
- Connect the output from the desired audio source to one of the LINE IN inputs.
- Connect the equipment to the mains.
Note: if you use the front LINE IN input, the LINE IN input on the back panel will be disabled.
CONFIGURATION
There are two ways to set the AIP-4010 audio transmitter:
- Through the net using the AIP-Go application.
- Through an external configuration file generated by the AIP-Go application.
THROUGH THE NET USING THE AIP-GO APPLICATION
To set the parameters on the AIP-4010 transmitter through the local area network, use the AIP-Go
application. Execute the program and perform the steps below:
Select the Device List option in the Devices menus. The window Network Devices will open. Select the
transmitter that you want to set and then press the button Configure.
- 5 -
Need help?
Do you have a question about the AIP-4010 and is the answer not in the manual?