EN
RESETTING THE DEFAULT VALUES
The AIP-4010 audio transmitter gives the option to set the equipment with the default values. To do this,
follow the steps below:
1.- Insert a cylindrical element with a diameter of less than 3 mm through the reset button hole on the front
panel of the equipemnt.
2.- Hold the reset button down for 20 seconds.
3.- Wait for an audio signal that will indicate that the equipment has been restarted with the default values.
AIP-4010 OPERATING STATUS
The red and blue indicators, together with the audio signals show the current status of the system. These
indications start working 30 seconds after switching the AIP-4010 transmitter on. Below you will find a
description of all the operating status for the equipment in accordance with the state of the indicators on the
front panel:
LED INDICATORS
Permanently alight in blue.
Stay alight in blue and blink once every 6
seconds.
Stay alight in blue and blink twice every 6
seconds.
Stay alight in blue and blink three times every
6 seconds.
Blink once in red every 6 seconds.
STATE / FUNCTION
Configuration of the IP address using DHCP and default
connection parameters.
Configuration of the fixed IP address and default
connection parameters.
Configuration of the IP address using DHCP and
different connection parameters to the default values.
Configuration of the fixed IP address and different
connection parameters to the default values.
Equipment with no network connection.
- 10 -
Need help?
Do you have a question about the AIP-4010 and is the answer not in the manual?