Selecting The Measuring Range; Selecting The Chemical Evaluation Form - Hach DR 2800 User Manual

Standard Operations

5.5.2 Selecting the Measuring Range

5.5.3 Selecting the Chemical Evaluation Form

5.5.3.1 Changing the Chemical Form Default Setting
40
3. Insert the sample cell or blank (depending on the working
procedure) into the cell compartment.
The measurement process and the result are displayed
automatically.
To evaluate other TNTplus cell tests and other parameters, place
the prepared cell in the cell compartment and read the result.
Some tests can be used for different measuring ranges. After the
sample cell has been inserted, a list of the different measuring
ranges is displayed.
Select the measuring range by pressing the appropriate line.
Press
START PERMANENT
subsequent measurements.
Changing the standard setting
In the result display, press
key now reads Permanent: Off.
The chemical form of the test result of a number of parameters can
be selected individually.
1. In the result display, press the unit (e.g. mg/L) or the chemical
representation of the evaluation form (e.g. PO
possible evaluation forms is displayed, from which the required
form can be selected. Press
Another way of changing the standard setting is:
1. In the result display, press
A list of available evaluation forms appears.
2. Press the required chemical form and confirm with
Note: The selected chemical form is displayed, but does not become
the default. To change the default form, see
1. Insert the sample cell or blank (depending on the working
procedure) into the cell compartment.
if this measuring range is to apply to all
> >
OPTIONS MORE PERMANENT: ON
3-
4
to confirm.
OK
> >
OPTIONS MORE CHEMICAL FORM
section 5.5.3.1.
. The
-P). A list of
.
.
OK