Hach DR 2800 User Manual page 49

6.1.1.1 Single Wavelength Programming
Selecting Units of Measure
Select the required unit from the list and press
Note: Units of measure not included in this list can be added in the edit
program under
PROGRAM OPTIONS>EDIT.
There is no "/" character available.
Defining the Wavelength
Use the numeric keypad to enter the measurement wavelength.
The entered wavelength must be in the range from 340–900 nm.
Press to proceed.
NEXT
Concentration Resolution
Select the required number of decimal places from the displayed
list and press .
NEXT
Setting the Chemical Form
Enter the chemical formula used in the display to represent the
analysis parameter.
Use the alphanumeric keypad to enter the chemical form and press
to enter Calibration settings. Go to
NEXT
to continue with Calibration.
Advanced Operations
.
NEXT
Select
UNITS>EDIT>NEW
section 6.1.1.3 on page 51
.
49