Advertisement
2.2.9 Transceiver Information Mode
Use this function to confirm the transceiver firmware version, SCM Firmware version and SCM Hardware version.
(1) Enter the Transceiver Information mode by using section "2.2.2 How to Enter Each Mode".
(2) The transceiver fi rmware version appears on the LCD.
(3) Use the [ ] and [ ] keys to select the confirmation items.
(4) To exit the transceiver information mode, turn the transceiver power OFF.
Note:
When the SCM board is not equipped to the transceiver, SCM Firmware Version and SCM Hardware Version are displayed
as "-.-.-."
2.3
INSTALLATION
2.3.1 SECURE CRYPTOGRAPHIC MODULE (KWD-AE30/KWD-AE31:Option)
2.3.2 SUPPLIED ACCESSORIES
Connecting cable *
(X42-3330-XX)
(G13-2179-XX)
Note:
Supplied accessories with * mark are not used for the NX-5300.
2.3.3 INSTALLING THE MODULE IN THE TRANSCEIVER
ATTENTION:
When installing the module, please take measures to prevent static electricity.
(1) Remove the VOID sheet.
CAUTION:
Regarding VOID, confirm the service policy of the NX-
5300 to KENWOOD (or authorized distributor). In addi-
tion, when installing the module, remove VOID sheet af-
ter understanding the service policy.
(2) Remove the 4 screws from the cover.
(3) Remove the cover and orange rubber seal from the trans-
ceiver.
Orange rubber seal
[
]/[
]
Cushion A *
Cushion B *
(G13-2178-XX)
VOID sheet
Cover
[
]/[
[
]/[
]
Cushion C *
(G1D-0006-XX)
(4) Remove the release paper from one side of cushion D,
then attach the cushion to the shielding case of the module.
Cushion D
Shielding case
Attach the cushion
correctly to the position of
the chassis and shielding
case (end-face).
(5) Insert the module to the connector of the PCB.
Module
]
Cushion D
(G1D-0055-XX)
Insert the cushion under the chassis.
Connector
(No.RA015<Rev.001>)1-11
Spacer
(F3K-0004-XX)
Hide quick links:
Advertisement
