Operation
mode
Standby
mode
Manual
mode
Installation
mode
Force
mode
5.5
Shutdown
WARNING:
In the standby mode, the unit is still in power-on status! In the standby mode, you
must disconnect the input power or two circuits of feeds (Feed A & Feed B) to get the
The manual mode is used to test if the components work normally or make
the system operate in accordance with the manual setting. In this mode, you
In the manual mode, press ESC to automatically return to the standby mode.
This mode is used to de-humidify and adjust the water balance. When it is
started, the two-way ball valve will fully open and the fans will rotate at the
minimum speed. When the system humidity falls within the operation scope,
the WARNING
beeps continuously until you leave the installation mode.
The two-way ball valve is fully open and the fans run at the highest speed.
This mode is generally used for unit testing or emergency cooling request.
System Mode
ON
Sure?
Description
Standby
Y/N
31
Chapter 5
Operation