Table of Contents
Advertisement
No.
6
7
8
9
10
Rear
components are shown in the table below.
InfraSuite RowCool Precision Cooling –
Chilled Water
Item
Output dry
contacts
Remote
temperature
sensor
Remote
temperature and
humidity
Display interface
Connect two dry contact output devices and trigger the
Port
6
dry contact device to this port and the device will be triggered
when an alarm event occurs (close the circuit). You may set
the triggering conditions. Refer to 5.7.1 Local setting.
Port
7
trigger to form a short circuit at the start of the cooling unit
to remind the chiller to output chilled water and turn to the
At most, three remote temperature sensors (two are provided)
and locate them for you in installation for accurate detection of
the temperature of heat loads.
Connects the remote temperature-humidity sensor (purchase
separately) for accurate detection of the temperature and
personnel perform installation.
Connects the control panel locating in front of the unit for
information output.
22
Description
Advertisement
Table of Contents
