Table of Contents
Advertisement
WARNING:
1. Only service personnel can perform the following installation procedures. No installation,
piping or handling should be performed without authorization so as to avoid equipment
damage and personal injury.
2. The high voltage in the equipment is potentially fatal! The inner components have potential
3.1
Installation Site
When planning the installation site for the cooling unit, you must take the following into
Environmental requirements
and pipe layout and repair. The cooling unit can only be located indoors and the indoor
environment must be isolated from the outside air to avoid temperature and humidity
interference. The outside humidity entry must be minimized in accordance with the local
or national regulations so as to avoid the increase of operation costs due to temperature
Humidity and heat source
Implement water-proof and heat insulation engineering for the indoor environment so as
to isolate the outside humid hot air. NOTE: If the humidity of the installation environment
in the water level of the condensed water pan, triggering an alarm.
Noise impact
At a high load, the operation of this cooling unit may produce loud noise. Therefore, it is not
Input power
In connecting the power supply, make sure that the power conforms to the rated value and
values of each unit and make sure they have been properly grounded. Do not connect
more than one cooling unit to the same branch circuit or power distribution equipment.
Chapter 3: Installation
11
Chapter 3
Installation
Advertisement
Table of Contents
