Brother ScanNCut DX Embossing Starter Kit Operation Manual page 7

c
Attach the material to be embossed to the low tack
adhesive mat, and then follow the on-screen instructions
to scan it.
• Follow the on-screen instructions to complete the procedure.
• If a highly adhesive mat is used, the surface of the material
may not be smooth.
• Attach the material so it does not extend from the attaching
area of the cutting mat.
• If the pattern extends out of the scanned material shown on the
LCD display screen, adjust the position of the pattern, or touch
and adjust the pattern size.
d
Check the template, and then touch the "OK" key.
e
Remove the material to be embossed from the mat. Firmly
attach the template sheet to the cutting mat.
• The template sheet does not have a front or back side.
7
f
Use the Auto Blade (Black Holder) to cut the template
sheet.
g
Feed out the mat, peel off the cut template sheet, and
then remove any leftover cutouts from the mat.

Follow the on screen instruction and finish making the
template sheet.
h
Select "Step 2: Emboss".