Brother ScanNCut DX Printable Sticker Starter Kit Operation Manual

Printable Sticker Starter Kit
EN
About the Printable Sticker Starter Kit
(For inkjet printers only.)
Using this kit, you can create custom stickers printed with your inkjet printer.
Affix the laminate sheet to improve water resistance.
When attached to resin or plastic, the sticker can be peeled off and reused.
Important Safety Instructions
CAUTION
• When peeling off stickers with the lifter, do not place your hand or fingers in the cutting path, otherwise injuries may result if the lifter
slips.
• Do not use the lifter in any way other than how it is intended.
Precautions
Depending on the material that the printable sticker is attached to, it may not cleanly peel off.
●
Do not use outdoors.
●
For detailed instructions on using the cutting machine, refer to the Operation Manual supplied with it.
●
Do not fold or bend the printable sticker or laminate sheet.
●
Do not store in a location exposed to direct sunlight, high temperatures or high humidity.
●
If the stickers are exposed to direct sunlight, the ink colors may fade or the material that they are attached to may yellow.
●
Affixing the laminate sheet provides water resistance; however, if the sticker is immersed in water for a long period of time, water
●
may seep in from the sides, causing the ink to run or the sticker to peel off.
Do not allow the printable sticker to come into direct contact with food, etc., since the printed ink may transfer.
●
Do not use in an environment at an extremely low or extremely high temperature.
●
The contents of this document are subject to change without notice.
●
The screens in this manual are for illustration purposes only and may differ from the actual screens.
●
1
Version 0