Brother ScanNCut DX Embossing Starter Kit Operation Manual page 5

e
Retrieve the pattern on the machine, and then feed in the
mat and touch to scan the material.
• Flip asymmetrical (mirror image) patterns to create the
embossed effect on the front surface of the material.
• Position the pattern so it does not extend from the material. If
the embossing tool touches the embossing mat, the mat may
be damaged.
• If the pattern extends out of the scanned material shown on the
LCD display screen, touch the "Edit" key to adjust the position
or size of the pattern.
f
Remove the embossing tool holder cap.
Select the embossing tool according to the line thickness
that you want to emboss, and then insert the embossing
tool into the embossing tool holder so that  on the tool
aligns with  on the holder. After securing the holder
cap, insert the holder into the cartridge.
• Before inserting the holder into the cartridge, check if the tool
moves up and down in the holder. If the tool moves, remove
the cap, and then attach it again.
5
g
Select "Emboss" on the preview screen.
h
Touch , and then specify the setting for "Emboss
Pressure".
• The recommended embossing pressure differs depending on
the material and embossing tool diameter. Refer to the
following table when adjusting the setting.
Material Thickness
Paper (thick) 0.25 mm
Metal sheets
-
(included)
Paper (thin) 0.1 mm
• This table of values provides general guidelines. Before making
your project, perform trial embossing with the same material.
Embossing Pressure
1.5 mm tool 3 mm tool
4 4
0 0
-6 -4