Memories; Select Fader Page; Memory Fader Modes; Memory Bump Modes - ETC SmartFade ML User Manual

Memories

Memories are played back from the faders in MEMS mode. In each of the 12 fader pages
the buttons with memories stored will light up dimmed in red when a page is selected. When
the fader is contributing to the output, the button will light up in full.
S e l e c t F a d e r P a g e
If a fader is above zero when a different page is selected, it will not be updated to the
content of the new page until it is brought to zero. Press MEMS twice within 1 second to
select page 1 quickly.
Action

Select fader page

M e m or y F a d e r M o d e s
Memories with both intensities and device parameters can behave in two ways when the
corresponding fader is moved. This is controlled with the INT ONLY button.
INT
ONLY
• OFF = Intensities and device parameters follow the fader progressively from zero to full.
• ON = Only intensities will follow the fader.
M e m or y B u m p M o d e s
When a bump button is pressed there are different behaviors for memories depending on
two modes: SOLO and GO MODE.
P i l e - o n o r S o l o
The content of memory faders can be bumped to the level of the BUMPS fader in two ways.
This is controlled with the SOLO button.
SOLO
• OFF = The level generated by pressing a bump button adds into the live output.
• ON = The level generated by pressing a bump button replaces the current output.
Go Mode
Device parameters in a memory can be bumped in two ways. This is controlled with the GO
MODE button.
GO
MODE
• OFF = Pressing a bump button adds device parameters and intensities temporarily into
the live output, following the rules of Pile-on and Solo.
• ON = Pressing a bump button activates all device parameters in this memory.
Intensities are not affected.
5
Playback
Console
(Held)
MEMS
Feedback
As long as the button is held, the current fader
page is indicated with a lit bump 1-12. To
select a new page, press bump 1-12 and let
go of the MEMS button.
83