Fuse Location And Identification; Check / Fill Transmission Oil Level; Transmission Oil Filter Change - Ferris SRS Z2 Series Operator's Manual

29

Fuse Location and Identification

Serial Number Range 2017576822 and Below:
The electrical system for this unit is equipped with a replaceable
fuse. See the chart below for the circuit, amperage, and
approximate location of the fuse.
Circuit Amperage
PTO Clutch 15 amp
Serial Number Range 2017576823 and Above:
The electrical system for this unit is equipped with two
replaceable fuses. See the chart below for the circuit, amperage,
and approximate location of the fuses.
Circuit Amperage
Main 20 amp
PTO Clutch 15 amp

Check / Fill Transmission Oil Level

Oil Type: SAE 20W-50 motor oil
This unit is equipped with two transmission oil tanks (A, Figure
30). One transmission oil tank only supplies oil to one
transmission. The level of oil in both transmission tanks must
be checked, and if necessary, filled.
28
30
1. Locate the transmission oil tanks. The transmission oil tanks
2. Check the oil level when the unit is cold. The oil should be
3. Before removing the tank cap (C), make sure that the area
4. Add oil up to the "FULL COLD" mark.
5. Re-install the tank caps.
6. After adding oil to the tanks, it may be necessary to purge
Approximate
Location
Left hand side of control
tower

Transmission Oil Filter Change

Change Interval: Every 400 Hours or Yearly (Initial hydraulic
oil and filter change after first 100 hours of operation)
Replacement Filter Number: 5101026X1
Note: Removing the oil filter from the transaxle will drain the oil
Approximate
tank. Have a suitable container ready to catch any spilled oil.
Location
The manufacturer recommends that this be a dealer-only service
Mounted by the battery
item.
box on the right hand
side of the machine.
1. Locate the transmission oil filters (A, Figure 31) underneath
Mounted under the
control panel on the right
hand side of the machine
are located on the right side of the engine between the
engine and the battery box.
up to the "FULL COLD" mark (B) on the transmission oil
tanks. If the oil is below this level, proceed to step #3.
around the tank caps and fill neck of the tank is free of dust,
dirt, and other debris. Remove the tank caps.
air from the hydraulic system. If the unit is not driving
properly perform the Purging the Air from the Hydraulic
System procedure.
the rear of the machine on the transmissions.
ferrismowers.com