Fuse Location And Identification; Check / Fill Transmission Oil Level; Transaxle Oil Filter Change - Ferris SRS Z2 Series Operator's Manual

wood can be used to support the operator support cushion in
the upright position while servicing the components beneath
the control tower.
29

Fuse Location and Identification

The electrical system for this unit is equipped with two
replaceable fuses. See the chart below for the circuit,
amperage, and approximate location of the fuses.
Circuit Amperage
Main 20 amp
PTO (Power Take Off) 15 amp
Clutch

Check / Fill Transmission Oil Level

Oil Type: SAE 20W-50 motor oil
This unit is equipped with two transmission oil tanks (A,
Figure 30). One transmission oil tank only supplies oil to one
transmission. The level of oil in both transmission tanks must
be checked, and if necessary, filled.
30
30
1. Locate the transmission oil tanks. The transmission oil
2. Check the oil level when the unit is cold. The oil should be
3. Before removing the tank cap (C), make sure that the
4. Add oil up to the "FULL COLD" mark.
5. Re-install the tank caps.
6. After adding oil to the tanks, it may be necessary to purge
Approximate
Location

Transaxle Oil Filter Change

Mounted by the battery
Change Interval: Every 400 Hours or Yearly (Initial transaxle
box on the right hand
side of the machine.
oil and filter change after first 100 hours of operation).
Mounted under the
Replacement Filter Number: 5101026X1
control panel on the
right hand side of the
Note: Removing the oil filter from the transaxle will drain
machine
the oil in the oil tank and the lines routed to the oil cooler.
Have a suitable container ready to catch the drained oil. The
manufacturer recommends that this be a dealer-only service
item.
1. Park the unit on a flat, level surface such as a concrete
2. Chock the front tires of the unit. Raise the rear of the unit
3. Remove the foot guard (A, Figure 31) and the hardware
tanks are located on the right side of the engine between
the engine and the battery box.
up to the "FULL COLD" mark (B) on the transmission oil
tanks. If the oil is below this level, proceed to step #3.
area around the tank caps and fill neck of the tank is free
of dust, dirt, and other debris. Remove the tank caps.
air from the hydraulic system. If the unit is not driving
properly perform the Purging the Air from the Hydraulic
System procedure.
floor. Engage the parking brake, disengage the PTO, turn
the ignition switch to OFF, and remove the ignition key.
so that the rear tires clear the ground and secure the unit
with jack stands.
that retains it to the back of the unit.
ferrismowers.com