Advertisement
SYMPTOMS
1. Poor flush.
2. No flush.
3. The fill valve turns on/off
by itself or it runs,
allowing water to enter
the tank.
4. Long tank fill cycle.
5. Noisy tank fill cycle.
1.
2.
3.
/
4.
5.
1207474-T01-A
A. Adjust the tank water level to match the waterline.
B. Fully open the water supply shut-off valve.
C. Clear obstructions from the trapway, jet, or bowl rim holes.
D. Clear obstructions from the waste line.
A. Make sure the push button rods are in place. Adjust as needed.
A. Check the position of flush valve cable, Flush valve cable must not overlap the valve float sinks.
B. Check the position of flush valve cable, flush valve cable must not obstructive the phase of flush
valve pipe.
C. Clean or replace the flush valve seal if it is worn, dirty, or misaligned with the valve seat or flush
valve seat is damaged.
D. Remove the tank and tighten the flush valve nut if flush valve gasket is leaking. Do not overtighten.
If leakage continues replace the gasket.
E. Clean the fill valve seal of debris or replace the seal assembly.
F. Replace the fill valve if the valve float sinks.
G. Adjust the tank water level if it is too high.
A. Fully open the water supply shut-off valve.
B. Clean the valve inlet, valve head, or supply line. Flush the lines.
A. Partially close the water supply shut-off valve if the water pressure to the toilet is too high. Check
the toilet performance following any such adjustment.
B. Remove dirt or obstructions from the valve head. Flush the lines.
A.
B.
C.
D.
A.
A.
B.
C.
D.
E.
F.
A.
B.
A.
B.
RECOMMENDED ACTION
/
-6-
Advertisement
