Location In Short Circuit For 4 Drivers Of Identical Section Mode (Option) - Made JUPITER PLUS User Manual

3.2.1.4.Location in short circuit for 4 drivers of identical
section mode (option)
Mode usable in all cases
The sensor intended for this function has two flexible loops, of
which one serves as a reference and the other for the
measurement (marked red).
• Connect the short circuit for 4 drivers to the end of the cable
• Connect the double loop to the Receiver; a press of the «
measurements » button lights the LED which indicates the
mode
• Put the loop marked
close it
• Put the unmarked loop around any other core and close it.
This core serves as a reference during the identification of
the other cores. This reference core will then be identified
by the
as reference
• Press the « measurements » button
• Wait for the result (3 seconds), either L1, L2 or L3 or
NEUTRAL
CORE IS THE ONE PASSING THROUGH THE LOOP
MARKED
• Repeat the operation to identify the other two cores
• Switch the loops after the last core has been identified, to
be able to identify the core which has served as reference.
IMPLEMENTATION
red loop using one of the previously identified cores
(blue LED on the connector), THE IDENTIFIED
RED
red around the core to identify, and
24 / 30