Implementation; Jupiter+ Transmiter - Made JUPITER PLUS User Manual

3. IMPLEMENTATION

3.1.JUPITER+ TRANSMITER

From turn-on by the operator, the Transmitter is activated and
generates the frequency signals necessary for identifying unpowered
MV & LV cables.
It is possible to turn the JUPITER+ Transmitter on S2 mode (with
different frequencies) for a utilization with two Transmitters at the
same time at the ends of a cable, one in S1 mode and the second on
S2 mode.
The type of utilization allows cores identification in open circuit once
the cable is cut at both ends without moving the Transmitter (useful
operation with replacing a joint or example).This Transmitter allows
only an utilization in S1 mode, or S2 mode with another Transmitter in
S1 mode.
Only one JUPITER+ Transmitter in S2 mode does not
allow core identification in open and short circuit
function!
The possible operations are :
• Identification of cables (Short-circuited ends)
• Continuity and identifying the cores with open circuit ends
(after cutting the cable)
• Identifying the cores with short circuited.
Once the Transmitter is started, no further action by the operator
is necessary to activate the functions described below.
When turned-on, the Transmitter is on S1 mode. A press on S1/S2
button activates S2 mode. Another press turn the Transmitter back to
S1 mode.
IMPLEMENTATION
12 / 30