Hardware Description - SMC Networks EZ Connect SMC2870W User Manual

H
ARDWARE
The Wireless Ethernet Bridge supports 1, 2, 5.5 and 11 Mbps
half-duplex connections to Ethernet networks. This device is fully
compliant with 2.4 GHz DSSS/OFDM wireless networking as
defined in IEEE 802.11b/g. The Wireless Ethernet Bridge is
backward compatible with the existing 802.11b WLAN
infrastructure. It also can be connected via an RJ-45 connection
to devices such as Nintendo GameCube, Microsoft Xbox, Sony
PlayStation II, and Ethernet ready embedded devices. It functions
as an IEEE 802.11g Access Point or as a Repeater (see
"Introduction" on page 1).
Power Connector
Figure 1. Rear Panel
Item Description
Power Inlet Connect the included power adapter to this inlet.
Warning: Using the wrong type of power adapter may damage
your adapter.
LAN Port Fast Ethernet port (RJ-45). Connect device (such as a PC, hub
or switch) on your local area network to this port.
Note: If you use the RELOAD button at the bottom, the Wireless
Ethernet Bridge performs a power reset. If the button is
depressed for over 5 seconds, all the LEDs will illuminate
and the factory settings will be restored.
D
ESCRIPTION
RJ-45 Port
3