MacDon FlexDraper FD1 Series Unloading And Assembly Instructions page 5

Updated center reel image and updated torque value.
Revised the high voltage limit adjustment instruction.
Added note at the beginning of each procedure.
Added settings specific to the two-sensor system.
Added note at the start and end of each procedure
about setting float.
214685
•
4.2.8 Converting from Medium Configuration or
Wide Configuration to Ultra Narrow Configuration,
page 47
•
4.2.9 Converting from Narrow Configuration to Ultra
Narrow Configuration, page 51
6.9 Centering Reel, page 116
Adjusting Voltage Limits: One-Sensor System, page
162
•
Calibrating the Auto Header Height Control (Case
IH 5088/6088/7088), page 170
•
Calibrating the Auto Header Height Control (Case
Combines with Version 28.00 or Higher Software),
page 191
•
Calibrating the Auto Header Height Control (New
Holland CR/CX Series), page 294
•
Calibrating the Auto Header Height Control (New
Holland CR Series), page 306
•
Setting up the Header on the Combine Display
(Case IH 5130/6130/7130; 5140/6140/7140), page
173
•
Calibrating the Auto Header Height Control
(Case IH 7010/8010, 7120/8120/9120,
7230/8230/9230, 7240/8240/9240), page 187
•
Calibrating the Auto Header Height Control (Case
Combines with Version 28.00 or Higher Software),
page 191
•
Calibrating Auto Header Height Control (Case IH
5130/6130/7130, 5140/6140/7140), page 177
•
Calibrating the Auto Header Height Control
(Case IH 7010/8010, 7120/8120/9120,
7230/8230/9230, 7240/8240/9240), page 187
•
Calibrating the Auto Header Height Control
(Challenger and Massey Ferguson), page 200
•
Calibrating the Auto Header Height Control
(Gleaner R65/R66/R75/R76 and Pre-2016
S Series), page 226
•
Calibrating the Auto Header Height Control (John
Deere 60 Series), page 248
•
Calibrating the Auto Header Height Control (John
Deere 70 Series), page 257
iii
Revision A