Table of Contents
Advertisement
Disconnect Engine Wiring and Fuel Hose
1. Disconnect battery ground cable from engine block
(A, Figure 9).
Figure 9
2. Disconnect the wire (B, Figure 10) from the oil
pressure switch.
Figure 10
3. Disconnect the wires (C, Figure 11) from the
temperature sensor.
Figure 11
4. Disconnect the wire from the oil warmer (if equipped)
and from the harness connector (A, Figure 12).
Figure 12
5. Disconnect fuel supply hose at mixer, hose clamp (D,
Figure 13), plug hose, and mixer inlet.
Figure 13
6. Remove the two mounting screws (E, Figure 14)
from the voltage regulator (F).
Figure 14
7. Carefully note the location of the wires connected to
the voltage regulator then disconnect the wires from
the regulator.
8. Push the regulator wire harness through the air duct
and into the center of the air plenum.
3
3
57
Hide quick links:
Advertisement
Table of Contents
