Table of Contents
Advertisement
Repair instructions
6
Unhook the cover from the keypad.
See figure 27
7
Dismantle the control unit.
See Chapter 7.10.
8
Dismantle the main switch.
See Chapter 7.12.
Cleaning and inspection
Clean and inspect all parts. They must always be
replaced with new ones if cracked or showing signs
of other defects. Always use original spare parts.
See figure 28
7.9 Assembling the main cable
1
Assemble the main switch.
See Chapter 7.13.
2
Assemble the control unit.
See Chapter 7.11.
3
Hook the cover onto the keypad.
See figure 27
4
(536LiBX)
Pull the main cables through the display cover.
Ensure there is no play between the cables and the
cover. See figure 28b.
Place all cables (in their attachments), control unit,
main switch and main cables into the chassis.
See figure 26a (436LiB, 536LiB).
See figure 26b (536LiBX).
NOTE!
Ensure cables, etc., are positioned correctly
to avoid pinching.
5
(436LiB, 536LiB)
Fasten the screws (A) for the battery contact.
Tightening torque 0.7±0.1 Nm.
See figure 25a (436LiB, 536LiB).
Fasten the screws holding the battery cable.
Tightening torque 1.9±0.1 Nm.
See figure 25b (536LiBX).
30
– English
Fig 27
Fig 28
Fig 28b
6
Assemble the cover over the electronics.
Tightening torque 0.7±0.1 Nm.
See figure 24
7
Assemble the motor housing/blow pipe.
See Chapter 7.7.
8
Assemble the contact spring.
See Chapter 7.5.
Advertisement
Table of Contents
