Samsung HHSM-G500005-1 Installation Manual page 27

Push the Mode
3.
then Tap
symbol should appear this indicates that the heater is on.
Push the Outing
4.
then appear to indicate that the DHW valve is open.
Now turn on the Room thermostats, 7E57 should now change to either Heat 1 or Heat 2 depending
5.
on what heating zone has been turned on. This indicates that the heat pump has received its run
signal from the room stats.
Use the Timer
6.
pump.
To come out of the test mode push and hold the Esc
7.
display.
button to bring on the immersion heater if using the system with a Cylinder,
button to force open the DHW valve, the Cylinder
button to view the temperature of the various sensors fitted to the heat
button until the 7E57 clears from the
Heat Pump Installation Guide
symbol should
27