Table of Contents
Advertisement
Pre-Installation Notes
•
Store the manual in a safe place in order to be able to use it as reference after installation. For
maximum safety installers should always carefully read the following warnings.
•
Store the provided manual in a safe location with the end user after installation, and remember
to hand it over to the new end user if the Heat Pump & Cylinder unit is sold or transferred.
•
The Air to Water Heat Pump is compliant with the requirements of the Low Voltage Directive
(2006/95/ EC), the EMC Directive (2004/108/EC) and the pressure equipment directive (97/23/EC).
•
The manufacturers shall not be responsible for damage originating from unauthorised changes
or the improper connection of electric and hydraulic lines.
•
Do not use units if you see some damages on the units and recognise something untoward
such as loud noise, smell or burning.
•
In order to prevent electric shocks, fires or injuries, always stop the unit, disable the protection
switch and contact Joule's technical support if the unit produces smoke, if the power cable is
hot or damaged, or if the unit is very noisy.
•
Always remember to inspect the unit, electric connections, refrigerant tubes and protections
regularly. These operations shall be performed by qualified personnel only.
•
The unit contains moving parts and electrical parts which should always be kept out of the
reach of children.
•
Do not attempt to repair, move, alter or reinstall the unit by unauthorised personnel. These
operations may cause product damage, electric shock and fires.
•
Do not place containers with liquids or other objects on the unit.
•
All the materials used for the manufacture and packaging of the air to water heat pump are re-
cyclable. The packaging material and exhaust batteries of the remote controller (optional) must
be disposed of in accordance with local regulations.
•
The Air to Water Heat Pump containing a refrigerant must be disposed in an authorised centre
or returned to retailer as special wastes.
•
Wear protective gloves to unpack, move, install, and service the unit to avoid your hands being
injured by the edge of the parts. Do not touch the internal parts (water pipes, refrigerant pipes,
heat exchangers, etc) while running the units. If you need to adjust and touch the units, allow
sufficient time for the unit to cool and be sure to wear protective gloves.
•
In case of refrigerant leakage, try to avoid contact with the refrigerant because this could result
in severe wounds.
•
When you install the Air-to-Water Heat Pump in a small room, you must install adequate venti-
lation. In the event of a refrigerant leakage, ventilation will prevent the possibility of suffocation.
Heat Pump Installation Guide
17
Hide quick links:
Advertisement
Table of Contents
