Hyundai Equus 2015 Owner's Manual page 149

3. Return to the vehicle and firmly
press, hold for two seconds and
then release the
®
HomeLink button. Repeat the
"press/hold/release" sequence a
second time to complete the pro-
gramming. (Some devices may
require you to repeat
sequence a third time to complete
the programming.)
4. Press and hold the just-trained
®
HomeLink button and observe
the red Status Indicator LED. If the
indicator light stays on constantly,
programming is complete and
your device should activate.
5. To program the remaining two
®
HomeLink buttons, follow either
steps 1 through 4 above for other
Rolling Code devices or steps 2
through 5 in Standard Programming
for standard devices.
Gate operator & Canadian
programming
desired
During programming, your handheld
transmitter may automatically stop
transmitting. Continue to press the
Integrated HomeLink
Control System button (note steps 2
this
through 4 in
Programming portion of this docu-
ment) while you press and re-press
("cycle") your handheld transmitter
every two seconds until the frequen-
cy signal has been learned. The indi-
cator light will flash slowly and then
rapidly after several seconds upon
successful training.
Operating HomeLink
To operate, simply press and release
the programmed HomeLink
Activation will now occur for the
trained device (i.e. garage door
opener, gate operator, security sys-
tem, entry door lock, home/office
lighting, etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time.
Reprogramming a single
HomeLink
To program a new device to a previ-
ously trained HomeLink
low these steps:
®
Wireless
1. Press
HomeLink
the Standard
until step 4 has been completed.
2. When the indicator light begins to
flash slowly (after 20 seconds),
position the handheld transmitter 1
to 3 inches away from the
HomeLink
3. Press and hold the handheld
transmitter button. The HomeLink
indicator light will flash, first slowly
and then rapidly.
®
4. When the indicator light begins to
flash rapidly, release both buttons.
®
button.
5. Press and hold the just-trained
HomeLink
the red Status Indicator LED. If the
indicator light stays on constantly,
programming is complete and
your new device should activate.
Features of your vehicle
®
button
®
button, fol-
and hold the desired
®
button. Do NOT release
®
surface.
®
®
button and observe
4 57